Sunday, April 27, 2008

Sc/Rambler Parts Requests For reproduction

Something not be reproduced yet , or want something to be better than what is currently available?? The Squeaky Wheel Gets The Grease !!!


Anomynous said:
rubber seals for the upper rear quarter glass (in the door jam)

I'll look at my car , not sure which seal you are referring too??
Most if not all rubber parts are available .
Inner fender rubber is not yet , but will put it up as a request
Bob

Chrome air cleaner cover , same as machine ...

Head rest clips pictured , luckily I was able to help somone out with these , my last two .
They are on a lot of cars , goes on the bottom of the head rest slide . The part that stays in the seat back .They clip onto a wire to stop the head rest from flopping .
http://i84.photobucket.com/albums/k25/underdog57/Clipsheadrest0001.jpg
http://i84.photobucket.com/albums/k25/underdog57/Clipsheadrest0002.jpg

SC/RAMBLER : GAS LINE GROMMET ?
The fuel line grommet needs to be reproduced or is there a commonly available substitute? Bill Strobel
Note :Gordy replies, I AM WORKING ON THE GROMMET NOW HOPE TO HAVE IT IN ABOUT 2 WEEKS

Hood Emblem , Same as on all 1969 Rambler 01 Americans . So a good chance ?!

- ORIGINAL LICENSE PLATE LIGHT


Rear sail Panel side dome lenses

"B" sheme decals ? Bottom blue looks easy to ruin(compound curves)

STEERING WHEEL AND CENTER

Etched Sill Plates Shared with AMX/Javelin and Two door 01 (americans) Big demand !

Front and Rear windsheilds (clear glass as OEM )
Note: Will take a crack at this , they can do this . Would like to know cost and qty needed to order ?

Hood pin Lanyards w/ clip (a more correct one)

DATED HOSE CLAMPS

CORRECT TRUNK MAT

Stock Lug Nuts
http://i84.photobucket.com/albums/k25/underdog57/mlewislugnuts1.jpg
http://i84.photobucket.com/albums/k25/underdog57/mlewislugnuts.jpg

Thrush Mufflers

Sun 635 tach plus cup/mount / wire/ clamp assembly

Rogue Door panel Emblem(s)

Crash(dash pads) They are pretty expensive , a batch order might get the cost down ??

Tire inflation decal (heard mention of these being done )
Amark is working on these along with a better jacking instruction sheet .
Note jacking instruction decals are ready ...

OEM style stainless beauty rings (NOS at $200.00 or close)

Radiator Top tank/ or radiator (319-4331)

Bumpers ?

Hardware kits (oem style )

Front Seat Chrome side cover ( Hearing they are coming )


Cowl rubber seal w/ clips

front fender anti squeek seals

No comments: