Jim McKee Clutch Bellcrank Mods

Modified clutch bellcrank. The welded stud the clutch rod used to be hooked to is ground off. This is the end to get the a rod end. Use a 3/8" bore-3/8"x 24 right hand thread economy female rod end. An economy, General Purpose, rod end is about $ 10.00 and will withstand over 5000 pounds load.





Here's the pictures of the bellcrank to throwout fork rod showing the 3/8" rod end on the bellcrank end and the stock AMC adjuster barrel on the other end of a 3/8" mild steel rod threaded 3/8"x 24 on both ends. A header tube is at the bottom of the picture